MotionLab outputs the readings to a disk file with a header that contains information about the test conditions.

Rec ID [100] and Test ID [3] are set in the Front Panel.

Up to eight Test Numbers [1] with the same or different Test Names may be run in an automatic sequence.  In this example, Test No. 1 is done with a subject’s Right Hand at Rest.

Measurements may be recorded as milli-g [1/1000th Earth gravity] or as mm/sec^2.

The Date [3/9/2007] and the Time [8:22 AM] of the test are automatically generated and the Rev Number [1.01] of the MotionLab program is recorded.

Samples [320] shows the number of samples taken and Sample Rate [160] is the rate at which the samples were taken.

Up/Dn, Rt/Lt and Ft/Bk are the axis directions relative to the TriAx accelerometer.

The numeric values are the acceleration readings for each sample and axis in the Measure Units used.

This listing is a spreadsheet view of the R100T3.mlr file.